Skip to main content
  • Pricing
Tutorials

How to Merge Audio Files Without Losing the Cut Points

By Oakgen TeamPublished 1 min read

Share
How to Merge Audio Files Without Losing the Cut Points

Merging audio can mean playing clips in order or combining tracks that play at the same time. Join a voice introduction and an interview in sequence. Mix a narration track and background music when both should be heard together. Make that decision before choosing an editing command.

Put two clips end to end

FFmpeg provides a concat filter for joining segments. This example creates one WAV from an introduction and an interview. It assumes already compatible audio settings.

ffmpeg -i intro.wav -i interview.wav -filter_complex '[0:a][1:a]concat=n=2:v=0:a=1[out]' -map '[out]' episode.wav

Play a few seconds before and after the cut. An abrupt change in room tone or loudness is easier to hear there than during a full replay. If the files come from different recorders, first check their sample rates and channels, then convert them to compatible settings in your editor. Keep your original recordings while testing.

Layer music and voice on separate tracks

Place the voice on its own track. Add the music beneath it, then lower the music during speech and listen on headphones and a small speaker. Avoid lining up a strong beat with the first word if it masks the start of a sentence. If a clip ends with an edit click, try a brief fade and listen again.

Before distributing the result, check the beginning, every join, and the final few seconds. Export with a filename that identifies the sequence and revision, retain a clean copy of the voice, and confirm you have the rights to any music in the mix.

Continue with Oakgen Agent

Coming soon: A dedicated one-click audio merger in Oakgen Agent.

Open in Oakgen Agent

The prompt is filled in for you. Review it before sending.

Open in Oakgen Agent

Sources

  1. FFmpeg documentation, concat and amix filters
Share