Skip to main content
  • Pricing
Tutorials

Use REAPER SWS Snapshots to Compare Mix Choices

By Oakgen TeamPublished 1 min read

Share
Use REAPER SWS Snapshots to Compare Mix Choices

SWS Snapshots can capture and recall selected REAPER mix settings. This makes them useful for a test where the timeline stays the same, such as deciding how far forward a vocal should sit against the drums.

Make one change you can hear

Save a copy of the project, then open the Snapshots window in REAPER with a compatible SWS installation available. Decide which parameters to capture before saving. For a level comparison, isolate the affected tracks and include volume. Add pan or effects settings only if you plan to test them as well.

Create a snapshot called “A – original vocal balance.” Raise the vocal slightly, leave the backing unchanged, and save “B – vocal raised.” Recall A and B over the same short chorus selection. If the change is subtle, run the comparison twice and write down which words became easier to hear.

Verify what recall changes

Inspect the track controls immediately after recalling each snapshot. Check that the expected faders changed and that the rest remained where you left them. If the wrong tracks are affected, review the window's filters and included tracks before making a fresh snapshot.

Snapshots record the parameters you selected. Keep your project file and media edits as a separate saved version. A short note next to each snapshot name, such as “lead +1.5 dB, chorus only,” lets you reconstruct what you were evaluating later.

Continue with Oakgen Agent

Open in Oakgen Agent

Review the prefilled prompt before sending.

Open in Oakgen Agent

Sources

  1. SWS Extension — Snapshots
  2. SWS Extension — Downloads and installation
Share