Skip to main content
  • Pricing
Tutorials

Quantitative Transfer to a Volumetric Flask

By Oakgen TeamPublished 1 min read

Share
Quantitative Transfer to a Volumetric Flask

Quantitative transfer is the goal of moving all of a measured substance into the receiving vessel. When making a solution, some may cling to the weighing container, funnel, or glassware. The Canadian Conservation Institute’s training transcript describes capturing the rinses in the same receiving flask so the solute stays in the preparation.

Keep the amount and the volume separate

Think of a classroom preparation intended to contain 0.0100 mol of dissolved table salt in a final volume of 0.1000 L. The planned concentration is 0.100 mol/L. If 0.0002 mol stays behind, the amount in the flask is 0.0098 mol. Filling to the correct final volume then gives 0.098 mol/L. Accurate volume measurement leaves the solute loss in the result.

A small rinse made with the appropriate solvent, collected in the flask before adjusting to final volume, can carry over residue during the transfer. The rinse counts toward the final volume. Filling to the mark before collecting all rinses can leave too much liquid in the flask.

Make an accounting sketch

Draw three boxes for the original container, the route through a funnel or stirring rod, and the final flask. Mark anywhere you could see residue after pouring. Then put a separate mark on the final volume line. This gives you two questions to check independently. Did the measured solute reach the receiving vessel, and did the finished solution reach the correct volume? Follow the assigned lab procedure for the actual solvent, vessel, and materials.

Continue with Oakgen Agent

Open in Oakgen Agent

Review the prefilled prompt before sending.

Open in Oakgen Agent

Sources

  1. Canadian Conservation Institute, A Conservator’s Guide to Preparing Solutions transcript
Share