Skip to main content
  • Pricing
Tutorials

Limiting Reactant With a BCA Table: Example

By Oakgen TeamPublished 1 min read

Share
Limiting Reactant With a BCA Table: Example

A Before, Change, After table tracks the mole amounts that enter and leave a balanced reaction. The limiting reactant is the one that runs out first. The table turns that chemical constraint into a calculation you can verify for each substance.

Start with the balanced equation

Use the classroom equation Nโ‚‚ + 3 Hโ‚‚ โ†’ 2 NHโ‚ƒ. Suppose the initial amounts are 2.0 mol of nitrogen, 3.0 mol of hydrogen, and no ammonia. Compare each initial reactant amount divided by its coefficient: 2.0 รท 1 = 2.0 for nitrogen and 3.0 รท 3 = 1.0 for hydrogen. The smaller value sets the reaction extent, so hydrogen is limiting under the assumed complete reaction.

RowNโ‚‚, molHโ‚‚, molNHโ‚ƒ, mol
Before2.03.00.0
Changeโˆ’1.0โˆ’3.0+2.0
After1.00.02.0

The change row follows the 1:3:2 coefficients. The table predicts 2.0 mol of ammonia, with 1.0 mol of nitrogen remaining. This is the theoretical prediction under the stated assumptions.

Catch two common errors

Convert grams to moles before applying the coefficients. They describe amounts in molecules or moles. Comparing two masses directly can produce the wrong limiting reactant.

Then check the final row for negative entries. A negative amount means the chosen change used more of a reactant than was present. Recalculate the maximum extent for each reactant. When both reach zero together, their starting amounts were in the exact stoichiometric ratio.

Continue with Oakgen Agent

Open in Oakgen Agent

The prompt is filled in for you. Review it before sending.

Open in Oakgen Agent

Sources

  1. OpenStax Chemistry 2e, Reaction Yields
Share