Skip to main content
  • Pricing
Tutorials

How to Draw a 2D Isometric Part in AutoCAD

By Oakgen TeamPublished 1 min read

Share
How to Draw a 2D Isometric Part in AutoCAD

An isometric sketch shows three faces of an object on a 2D sheet. In AutoCAD, the active isoplane directs the drafting aids, so choosing the face first keeps the edges and holes consistent.

Draw a sample plate

  1. Run ISODRAFT and choose Top. With Ortho on, use the two sloping axes to draw the top face of a plate. Try side lengths of 60 and 40 drawing units.
  2. Choose Left or Right when drawing along a vertical side face. Drop the visible corners by 10 units and connect their ends on the same axes as the corresponding top edges.
  3. Switch back to Top for a centered round hole. Locate the top face's center at the intersection of its diagonals. Run ELLIPSE, choose Isocircle, then mark that center and enter a radius of 7 units. Use a construction layer for the diagonals if you want to hide them.

If the hole appears to stand upright on the plate, it was probably drawn on a side isoplane. Redraw it with the top isoplane active. The ellipse represents the circular hole as it appears in that view.

Decide what to hand over

This workflow gives you a 2D illustration you can label and annotate. Save a separate copy of an actual solid model when someone needs to change the viewing angle, compute a volume, or generate new orthographic views.

Continue with Oakgen Agent

Open in Oakgen Agent

Review the prefilled prompt before sending.

Open in Oakgen Agent

Sources

  1. Autodesk — ISODRAFT command
  2. Autodesk — Create 2D isometric circles
Share